Teledyne LeCroy Sierra M6-4 SAS_SATA Protocol Analyzer User Manual - Manual (Page 442)

Teledyne LeCroy Sierra Trainer Generation Language
438 Sierra M6‐4 SAS/SATA Protocol Analyzer User Manual
 SSP_FRAME_TYPE_COMMAND
 SSP_FRAME_TYPE_RESPONSE
 SSP_FRAME_TYPE_TASK
 SSP_FRAME_TYPE_VENDOR
 MUX (LOGICAL 0)
 MUX (LOGICAL 1)
 BREAK_REPLY
 TRAIN
 TRAIN_DONE
 PS_ACK
 PS_NAK
 PS_REQ_PARTIAL
 PS_REQ_SLUMBER
Primitive Category
 ALIGN: 0, 1, 2, or 3
 NOTIFY: ENABLE SPINUP, RESERVED 0, RESERVED 1, or RESERVED 2
 ACK
 NAK: CRC ERROR, RESERVED 0, RESERVED 1, or RESERVED 2
 RRDY: NORMAL, RESERVED 0, RESERVED 1
 AIP: NORMAL, RESERVED 0, RESERVED 1, RESERVED 2, RESERVED 3, WAITING
ON CONNECTION, WAITING ON DEVICE, or WAITING ON PARTIAL
 BREAK
 CLOSE: CLEAR AFFILIATION, NORMAL, RESERVED 0, RESERVED 1
 CREDIT BLOCKED
 OPEN ACCEPT
 OPEN REJECT: BAD DESTINATION, CONNECTION RATE NOT SUPPORTED, NO DES‐
TINATION, PATHWAY BLOCKED, PROTOCOL NOT SUPPORTED, RESERVED ABAN‐
DON 0, RESERVED ABANDON 1, RESERVED ABANDON 2, RESERVED ABANDON 3,
RESERVED CONTINUE 0, RESERVED CONTINUE 1, RESERVED INITIALIZE 0,
RESERVED INITIALIZE 1, RESERVED STOP 0, RESERVED STOP 1, RETRY, STP
RESOURCES BUSY, or WRONG DESTINATION
 BROADCAST: CHANGE, RESERVED 0, RESERVED 1, RESERVED 2, RESERVED 3,
RESERVED 4, RESERVED CHANGE 0, or RESERVED CHANGE 1
 DONE: ACK/NAK TIMEOUT, CREDIT TIMEOUT, NORMAL, RESERVED 0, RESERVED
1, RESERVED TIMEOUT 0, or RESERVED TIMEOUT 1
 SATA FLOW CTRL PRIMITIVE
 SATA IDLE PRIMITIVE
 SAS PS PRIMITIVE: PS_REQ_PARTIAL, PS_REQ_SLUMBER, PS_ACK, or PS_NAK
Wait Commands
Syntax:
WAIT_FOR { ... ... }