Teledyne LeCroy Sierra M6-4 SAS_SATA Protocol Analyzer User Manual - Manual (Page 367)

Sierra M6‐4 SAS/SATA Protocol Analyzer User Manual 363
Creating Global Rules Teledyne LeCroy
Figure 4.23: Using a Captured Data DWORD in Substitute DWORD Test Action
4.8.5 Summary of Scenario Creation
The suggested process of creating and executing a scenario is as follows:
1. Create a scenario in the main library.
2. Copy the scenario from main library to a device library by drag‐and‐drop with a
mouse. (Each device library is associated with a specific InFusion device.)
3. Download all scenarios in the device library to a InFusion device.
4. Select the scenario in the device library that you want to run on the device.
5. To run the scenario, click the Start Scenario button from the Device Library toolbar.
The device starts to monitor/modify traffic.
Note: Step 1 is described in detail for each example in following sections. Steps 2 to 5 are described in
detail at the end of this chapter.
4.9 Creating Global Rules
This section gives examples for creating the Global Rules area of a scenario. Recall that
the Global Rules area defines a single test state. The Global Rules do not have the capacity
for multiple states, so that area of a scenario cannot change state.
In terms of InFusion testing, a state defines test “behavior.” In this context, behavior is
“waiting” for an event and responding with an action or set of actions that happen
simultaneously.