Fortinet 548B - Manual (Page 968)

- 968 -
Selection Criteria
Source IP - Enter the IP address of the multicast packet source to be combined with the Group IP to
fully identify a single route whose Mroute table entry you want to display or clear. You may leave this
field blank.
Group IP - Enter the destination group IP address whose multicast route(s) you want to display or
clear.
Non-Configurable Data
Incoming Interface - The incoming interface on which multicast packets for this source/group arrive.
Outgoing Interface(s) - The list of outgoing interfaces on which multicast packets for this
source/group are forwarded.
Up Time (secs)- The time in seconds since the entry was created.
Expiry Time (secs)- The time in seconds before this entry will age out and be removed from the
table.
RPF Neighbor - The IP address of the Reverse Path Forwarding neighbor.
Protocol - The multicast routing protocol which created this entry. The possibilities are:

PIM-DM

PIM-SM

DVMRP
Flags - The value displayed in this field is valid if the multicast routing protocol running is PIMSM.
The possible values are RPT or SPT. For other protocols a "------" is displayed.
Command Buttons
Search - Search the Mroute table for an entry matching the Source IP (if entered) and Group IP
address.
Refresh - Refresh the information on the screen with the present state of the data in the router.