Fortinet 548B - Manual (Page 437)

- 437 -
8.3.1.4 show ip ospf asbr
This command displays the internal OSPF routing table entries to Autonomous System Boundary
Routers (ASBR). This command takes no options.
Syntax
show ip ospf asbr
Default Setting
None
Command Mode
Privileged Exec
User Exec
Display Messages
Type: The type of the route to the destination. It can be one of the following values:

intra — Intra-area route

inter — Inter-area route
Router ID: Router ID of the destination.
Cost: Cost of using this route.
Area ID: The area ID of the area from which this route is learned.
Next Hop: Next hop toward the destination.
Next Hop Intf: The outgoing router interface to use when forwarding traffic to the next hop.
8.3.1.5 show ip ospf database
This command displays information about the link state database when OSPF is enabled. If you do not
enter any parameters the command displays the LSA headers for all areas. Use the optional
parameter to display database information about a specific area. Use the optional parameters to specify
the type of link state advertisements to display.
Syntax
sow ip ospf [] database [{database-summary | [{asbr-summary network | nssa-external |
opaque-area | opaque-as | opaque-link | mmary}] [] [{adv-router [] | self-originate}]}]
asbr-summary - Use asbr-summary to show the autonomous system boundary router (ASBR)
summary LSAs.
external - Use external to display the external LSAs.
Network - Use network to display the network LSAs.