Fortinet 548B - Manual (Page 605)

- 605 -
no - Use this command to set the PIM-DM hello interval to the default value.
Default Setting
Disabled
Command Mode
Interface Config
10.7 Protocol Independent Multicast
– Sparse Mode (PIM-SM) Commands
10.7.1 Show Commands
10.7.1.1 show ipv6 pimsm
This command displays the system-wide information for PIM-SM.
Syntax
show ipv6 pimsm
Default Setting
None
Command Mode
Privileged Exec
User Exec
Display Message
Admin Mode: Indicates whether PIM-SM is enabled or disabled.
Data Threshold Rate (Kbps): The data threshold rate for the PIM-SM router.
Register Threshold Rate (Kbps): The threshold rate for the RP router to switch to the shortest
path.
SSM Range Table Group Address/Prefix Length
PIM-SM Interface Status:
Interface: Valid unit, slot, and port number separated by forward slashes.
Interface Mode: Indicates whether PIM-SM is enabled or disabled on the interface.
Operational State: The current state of the PIM-SM protocol on the interface. Possible values
are Operational or Non- Operational.