Fortinet 548B - Manual (Page 557)

- 557 -
10.3.2.3 ipv6 unicast-routing
Use this command to enable the forwarding of IPv6 unicast packets.
Syntax
ipv6 unicast-routing
no ipv6 unicast-routing
no – Use this command to disable the forwarding of IPv6 unicast packets.
Default Setting
Disabled
Command Mode
Global Config
10.3.2.4 ipv6 enable
Use this command to enable IPv6 routing on an interface, including a tunnel and loopback interface that
has not been configured with an explicit IPv6 address. When you use this command, the interface is
automatically configured with a link-local address. You do not need to use this command if you
configured an IPv6 global address on the interface.
Syntax
ipv6 enable
no ipv6 enable
no – Use this command to disable IPv6 routing on an interface.
Default Setting
Disabled
Command Mode
Interface Config
Interface VLAN
10.3.2.5 ipv6 address
Use this command to configure an IPv6 address on an interface, including tunnel and loopback
interfaces, and to enable IPv6 processing on this interface. You can assign multiple globally reachable
addresses to an interface by using this command. You do not need to assign a linklocal address by