Fortinet 548B - Manual (Page 509)

- 509 -
MLD Version: Indicates the version of MLD configured on the interface.
Query Interval: Indicates the configured query interval for the interface.
Query Max Response Time: Indicates the configured maximum query response time (in seconds)
advertised in MLD queries on this interface.
Robustness: Displays the configured value for the tuning for the expected packet loss on a subnet
attached to the interface.
Startup Query interval: This valued indicates the configured interval between General Queries sent
by a Querier on startup.
Startup Query Count: This value indicates the configured number of Queries sent out on startup,
separated by the Startup Query Interval.
Last Member Query Interval: This value indicates the configured Maximum Response Time
inserted into Group-Specific Queries sent in response to Leave Group messages.
Last Member Query Count: This value indicates the configured number of Group-Specific Queries
sent before the router assumes that there are no local members.
The following information is displayed if the operational mode of the MLD interface is enabled.
Querier Status: This value indicates whether the interface is an MLD querier or non-querier on the
subnet it is associated with.
Querier Address: The IP address of the MLD querier on the subnet the interface is associated with.
Querier Up Time: Time elapsed in seconds since the querier state has been updated.
Querier Expiry Time: Time left in seconds before the Querier loses its title as querier.
Wrong Version Queries: Indicates the number of queries received whose MLD version does not
match the MLD version of the interface.
Number of Joins: The number of times a group membership has been added on this interface.
Number of Leaves: The number of times a group membership has been removed on this interface.
Number of Groups: The current number of membership entries for this interface.
9.3.1.3 show ipv6 mld traffic
Use this command to display MLD statistical information for the router.
Syntax
show ipv6 mld traffic
Default Setting
None
Command Mode
Privileged Exec
Display Message
Valid MLD Packets Received: The number of valid MLD packets received by the router.
Valid MLD Packets Sent: The number of valid MLD packets sent by the router.