3 serviceport ip – Fortinet 548B User Manual
Page 199
- 199 -
Default Setting
None
Command Mode
Privileged Exec
Display Message
IPv6 Address: Specifies the IPv6 address of neighbor or interface.
MAC Address: Specifies MAC address associated with an interface.
isRr:. Specifies router flag.
Neighbor State:
Incmp - Address resolution is being performed on the entry. A neighbor solicitation message has
been sent to the solicited-node multicast address of the target, but the corresponding neighbor
advertisement message has not yet been received.
Reach - Positive confirmation was received within the last Reachable Time milliseconds that the
forward path to the neighbor was functioning properly. While in REACH state, the device takes
no special action as packets are sent.
Stale - More than ReachableTime milliseconds have elapsed since the last positive confirmation
was received that the forward path was functioning properly. While in STALE state, the device
takes no action until a packet is sent.
Delay - More than ReachableTime milliseconds have elapsed since the last positive confirmation
was received that the forward path was functioning properly. A packet was sent within the last
DELAY_FIRST_PROBE_TIME seconds. If no reachability confirmation is received within
DELAY_FIRST_PROBE_TIME seconds of entering the DELAY state, send a neighbor
solicitation message and change the state to PROBE.
Probe - A reachability confirmation is actively sought by resending neighbor solicitation
messages every RetransTimer milliseconds until a reachability confirmation is received.
Age Updated: Time since the address was confirmed to be reachable.
7.3.14.3 serviceport ip
This command sets the IP address, the netmask and the gateway of the network management
port.
Syntax
serviceport ip
Default Setting
None