Fortinet 548B - Manual (Page 128)

- 128 -
7.2.11.2 storm-control broadcast
This command enables broadcast storm recovery mode on the selected interface. If the mode is
enabled, broadcast storm recovery with high threshold is implemented. The threshold implementation
follows a percentage pattern. If the broadcast traffic on any Ethernet port exceeds the high threshold
percentage (as represented in “Broadcast Storm Recovery Thresholds” table) of the link speed, the
switch discards the broadcasts traffic until the broadcast traffic returns to the threshold percentage or
less. The
full implementation is depicted in the “Broadcast Storm Recovery Thresholds” table.
Syntax
storm-control broadcast
no storm-control broadcast
no - This command disables broadcast storm recovery mode on the selected interface. The
threshold implementation follows a percentage pattern. If the broadcast traffic on any Ethernet port
exceeds the high t
hreshold percentage (as represented in “Broadcast Storm Recovery Thresholds”
table) of the link speed, the switch discards the broadcasts traffic until the broadcast traffic returns to
the threshold percentage or less. The full implementation is depicted i
n the “Broadcast Storm
Recovery Thresholds” table.
Default Setting
Disabled
Command Mode
Interface Config
This command enables broadcast storm recovery mode on all interfaces.
Syntax
storm-control broadcast
no storm-control broadcast
no - This command disables broadcast storm recovery mode on all interfaces.
Default Setting
Disabled
Command Mode
GlobaI Config
7.2.11.3 storm-control multicast
This command enables multicast storm recovery mode on the selected interface.