Fortinet 548B - Manual (Page 434)

- 434 -
LSA Count: The total number of link state advertisements currently in the link state database.
Maximum Number of LSAs: The maximum number of LSAs that OSPF can store.
LSA High Water Mark: The maximum size of the link state database since the system started.
Retransmit List Entries: The total number of LSAs waiting to be acknowledged by all neighbors. An
LSA may be pending acknowledgment from more than one neighbor.
Maximum Number of Retransmit Entries: The maximum number of LSAs that can be waiting for
acknowledgment at any given time.
Retransmit Entries High Water Mark: The highest number of LSAs that have been waiting for
acknowledgment.
External LSDB Limit: The maximum number of non-default AS-external-LSAs entries that can be
stored in the link-state database.
Default Metric: Default value for redistributed routes.
Default Passive Setting: Shows whether the interfaces are passive by default.
Default Route Advertise: Indicates whether the default routes received from other source protocols
are advertised or not.
Always: Shows whether default routes are always advertised.
Metric: The metric of the routes being redistributed. If the metric is not configured, this field is blank.
Metric Type: Shows whether the routes are External Type 1 or External Type 2.
Number of Active Areas: The number of active OSPF areas. An “active” OSPF area is an area with
at least one interface up.
AutoCost Ref BW: Shows the value of auto-cost reference bandwidth configured on the router.
Maximum Paths: The maximum number of paths that OSPF can report for a given destination.
Redistributing: This field is a heading and appears only if you configure the system to take routes
learned from a non-OSPF source and advertise them to its peers.
Source: The source protocol/routes that are being redistributed. Possible values are static,
connected, BGP, or RIP.
Tag: The decimal value attached to each external route.
Subnets: For redistributing routes into OSPF, the scope of redistribution for the specified protocol.
Distribute-List: The access list used to filter redistributed routes.
8.3.1.2 show ip ospf abr
This command displays the internal OSPF routing table entries to Area Border Routers (ABR). This
command takes no options
Syntax
show ip ospf abr
Default Setting
None