Fortinet 548B - Manual (Page 294)

- 294 -
7.12.2 Configuration Commands
7.12.2.1 lldp notification
This command uses to enable remote data change notifications.
Syntax
lldp notification
no lldp notification
no - This command is used to disable notifications.
Default Setting
Disbaled
Command Mode
Interface Config
7.12.2.2 lldp notification-interval
This command is used to configure how frequently the system sends remote data change notifications.
The parameter is the number of seconds to wait between sending notifications. The
valid interval range is 5-3600 seconds.
Syntax
lldp notification-interval
no lldp notification-interval
- Configures the number of seconds to wait between sending notifications.
no - This command is used to return the notification interval to the default value.
Default Setting
5
Command Mode
Global Config