Fortinet 548B - Manual (Page 283)

- 283 -
7.11.2.4 voice vlan
This command is used to enable/disable Voice VLAN Admin Mode.
Syntax
voice vlan
no voice vlan
no - This command disables the Voice VLAN capability on this switch.
Default Setting
Disabled
Command Mode
Global Config
This command configures the Voice VLAN capability on the interface.
Syntax
voice vlan { | dot1p | none | untagged }
no voice vlan
- Configure the IP phone to forward all voice traffic through the specified VLAN.
- Configure th IP phone to use 802.1p priority tagging for voice traffic and to use the default
native VLAN (0) to carry all traffic. The valid range is 0 to 7.
- Allow the IP phone to use its own configuration to send untagged voice traffic.
- Configure the phone to send untagged voice traffic.
no - This command disables the Voice VLAN capability on this switch.
Default Setting
Disabled
Command Mode
Interface Config