Fortinet 548B - Manual (Page 752)

- 752 -
Selection Criteria
Spanning Tree Mode - Specifies whether spanning tree operation is enabled on the switch. Value is
enabled or disabled
Spanning Tree Forward BPDU - Specifies whether spanning tree for BPDU is enabled on the
switch. Value is enabled or disabled.
Force Protocol Version - Specifies the Force Protocol Version parameter for the switch. The
options are IEEE 802.1d, IEEE 802.1w, and IEEE 802.1s The default value is IEEE 802.1w.
Configurable Data
Configuration Name- Identifier used to identify the configuration currently being used. It may be up
to 32 alphanumeric characters
Configuration Revision Level - Identifier used to identify the configuration currently being used.
The values allowed are between 0 and 65535. The default value is 0.
Non-Configurable Data
Configuration digest key - Identifier used to identify the configuration currently being used.
MST Table - Table consisting of the MST instances (including the CST) and the corresponding
VLAN IDs associated with each of them.
VID Table - Table consisting of the VLAN IDs and the corresponding FID associated with each of
them.
FID Table - Table consisting of the FIDs and the corresponding VLAN IDs associated with each of
them.
Command Buttons
Submit - Applies the new configuration and causes the changes to take effect. These changes will
not be retained across a power cycle unless a save configuration is performed.
Refresh - Refreshes the screen with most recent data.
11.3.19.2 Configuring Spanning Tree CST Configuration Page