Fortinet 548B - Manual (Page 529)

- 529 -
The parameter is the group mask for the group address. The optional keyword override
indicates that if there is a conflict, the RP configured with this command prevails over the RP learned by
BSR.
Syntax
ip pimsm rp-address [override]
no ip pimsm rp-address
- the IP Address of the RP.
- the group address supported by the RP.
- the group mask for the group address.
no - This command is used to delete RP IP address for the PIM-SM router. The parameter
is the IP address of the RP. The parameter is the group address
supported by the RP. The parameter is the group mask for the group address.
Default Setting
None
Command Mode
Global Config
9.6.2.6 ip pimsm
This command sets administrative mode of PIM-SM multicast routing on a routing interface to enable.
Syntax
ip pimsm
no ip pimsm
no - This command sets administrative mode of PIM-SM multicast routing on a routing interface to
disabled.
Default Setting
Disbaled
Command Mode
Interface Config
9.6.2.7 ip pimsm hello-interval
This command configures the transmission frequency of hello messages in seconds between PIM
enabled neighbors. This field has a range of 0 to 18000 seconds.