Fortinet 548B - Manual (Page 904)

- 904 -
Ethertype User Value - Specifies the user defined customised Ethertype value to be used when the
user has selected "User Value" as Ethertype Key, to compare against an Ethernet frame. Valid
range of values is (0x0600 to 0xFFFF).
Source MAC - Specifies the Source MAC address to compare against an Ethernet frame. Valid
format is (xx:xx:xx:xx:xx:xx).
Source MAC Mask - Specifies the Source MAC address mask specifying which bits in the Source
MAC to compare against an Ethernet frame. Valid format is (xx:xx:xx:xx:xx:xx).
VLAN - Specifies the VLAN ID to compare against an Ethernet frame. Valid range of values is (1 to
3965). Either VLAN Range or VLAN can be configured.
Match Every - Specifies an indication to match every Layer 2 MAC packet.
Valid values are

True - Signifies that every packet is considered to match the selected ACL Rule.

False - Signifies that it is not mandatory for every packet to match the selected ACL Rule.
Command Buttons
Configure - Configure the corresponding match criteria for the selected rule.
Submit - Send the updated configuration to the switch. Configuration changes take effect
immediately. These changes will not be retained across a power cycle unless a save is performed.
Delete - Remove the currently selected Rule from the selected ACL. These changes will not be
retained across a power cycle unless a save configuration is performed.
11.7.1.10 Configuring Access Control List Interface Configuration Page
Selection Criteria
Slot/Port - Specifies list of all available valid interfaces for ACL mapping. All non-routing physical
interfaces and interfaces participating in LAGs are listed.
Direction - Specifies the packet filtering direction for ACL. Valid Directions:

Inbound
ACL Type - Specifies the type of ACL. Valid ACL Types:

IP ACL

IPv6 ACL