Fortinet 548B - Manual (Page 803)

- 803 -
The State is only displayed if the OSPF admin mode is enabled.
Designated Router - The identity of the Designated Router for this network, in the view of the
advertising router. The Designated Router is identified here by its router ID. The value 0.0.0.0 means
that there is no Designated Router. This field is only displayed if the OSPF admin mode is enabled.
Backup Designated Router - The identity of the Backup Designated Router for this network, in the
view of the advertising router. The Backup Designated Router is identified here by its router ID. Set
to 0.0.0.0 if there is no Backup Designated Router. This field is only displayed if the OSPF admin
mode is enabled.
Local Link LSAs - The number of opaque LSAs whose flooding scope is the link on this interface.
Link Local LSA Checksums - The sum of the checksums of local link LSAs for this link.
Number of Link Events - This is the number of times the specified OSPF interface has changed its
state. This field is only displayed if the OSPF admin mode is enabled.
Command Buttons
Configure Authentication - Display a new screen where you can select the authentication method
for the virtual link.
Submit - Send the updated configuration to the switch. Configuration changes take effect
immediately. These changes will not be retained across a power cycle unless a save is performed.
11.4.3.7 Viewing Neighbor Table Information
This panel displays the OSPF neighbor table list. When a particular neighbor ID is specified, detailed
information about a neighbor is given. The information below will only be displayed if OSPF is enabled.
Selection Criteria
Slot/Port - Selects the interface for which data is to be displayed or configured. Slot 0 is the base
unit.
Non-Configurable Data
Router ID - A 32 bit integer in dotted decimal format representing the neighbor interface.
IP Address - The IP address of the neighboring router's interface to the attached network. It is used
as the destination IP address when protocol packets are sent as unicasts along this adjacency. Also
used in router-LSAs as the Link ID for the attached network if the neighboring router is selected to be
designated router. The Neighbor IP address is learned when Hello packets are received from the
neighbor. For virtual links, the Neighbor IP address is learned during the routing table build process.
Neighbor Interface Index - A Slot/Port identifying the neighbor interface index.