Fortinet 548B - Manual (Page 392)

- 392 -
ACL ID: Access List name for a MAC or IPv6 access list or the numeric identifier for an IP access
list.
Sequence Number: An optional sequence number may be specified to indicate the order of this
access list relative to other access lists already assigned to this interface and direction. A lower
number indicates higher precedence order. If a sequence number is already in use for this interface
and direction, the specified access list replaces the currently attached access list using that
sequence number. If the sequence number is not specified by the user, a sequence number that is
one greater than the highest sequence number currently in use for this interface and direction is
used. Valid range is (1 to 4294967295).
7.22.2 Configuration Commands
7.22.2.1 mac access-list extended
This command creates a MAC Access Control List (ACL) identified by , consisting of
classification fields defined for the Layer 2 header of an Ethernet frame. The parameter is a
case-sensitive alphanumeric string from 1 to 31 characters uniquely identifying the MAC access list. If a
MAC ACL by this name already exists, this command enters Mac-Access-List config mode to allow
updating the existing ACL.
Syntax
mac access-list extended
no mac access-list extended
- It uniquely identifies the MAC access list.
Default Setting
None
Command Mode
Global Config
7.22.2.2 mac access-list extended rename
This command changes the name of a MAC Access Control List (ACL). The parameter is the
name of an existing MAC ACL. The parameter is a case-sensitive alphanumeric string from
1 to 31 characters uniquely identifying the MAC access list. This command fails if a MAC ACL by the
name already exists.
Syntax
mac access-list extended rename
- Old name which uniquely identifies the MAC access list.