Fortinet 548B - Manual (Page 577)

- 577 -
User Exec
Display Messages
Area ID: The area id of the requested OSPF area.
IP Address: An IP Address which represents this area range.
Subnet Mask: A valid subnet mask for this area range.
Lsdb Type: The type of link advertisement associated with this area range.
Advertisement: The status of the advertisement. Advertisement has two possible settings: enabled
or disabled.
10.4.1.12 show ipv6 ospf stub table
This command displays the OSPF stub table. The information bello will only be displayed if OSPF is
initialized on the switch.
Syntax
show ipv6 ospf stub table
Default Setting
None
Command Mode
Privileged Exec
User Exec
Display Messages
Area ID: Is a 32-bit identifier for the created stub area.
Type of Service: Is the type of service associated with the stub metric. Only supports Normal TOS.
Metric Val: The metric value is applied based on the TOS. It defaults to the least metric of the
type of service among the interfaces to other areas. The OSPF cost for a route is a
function of the metric value.
Import Summary LSA: Controls the import of summary LSAs into stub areas.
10.4.1.13 show ipv6 ospf virtual-link
This command displays the OSPF Virtual Interface information for a specific area and neighbor.
Syntax
show ip ospfv6 virtual-link