Fortinet 548B - Manual (Page 156)

- 156 -
Command Mode
Global Config
7.3.1.7 ip address protocol
This command specifies the network configuration protocol to be used. If you modify this value, the
change is effective immediately.
Syntax
ip address protocol {bootp | dhcp | none}
- Obtains IP address from BOOTP.
- Obtains IP address from DHCP.
- Obtains IP address by setting configuration.
Default Setting
None
Command Mode
Interface-Vlan Config
7.3.1.8 ip filter
This command is used to enable the IP filter function.
Syntax
ip filter
no ip filter
no – Disable ip filter.
Default Setting
Disabled
Command Mode
Global Config