Fortinet 548B - Manual (Page 677)

- 677 -
Selection Criteria
Ping - Select either global IPv6 Address or Link Local Address to ping.
Interface - Select a IPv6 interface.
Configurable Data
IPv6 Address - Enter the IPv6 address of the station you want the switch to ping. The initial value is
blank. The IPv6 Address you enter is not retained across a power cycle.
Host name - Enter the host name of the station you want the switch to ping.
Link Local Address - Enter the link local address of the station you want the switch to ping. The
initial value is blank. The Link Local Address you enter is not retained across a power cycle.
Datagram Size - Enter the datagram size. The valid range is 48 to 2048.
Non-Configurable Data
Ping Output – The reply result received from switch.
Command Buttons
Submit - This will initiate the ping.
11.2.10.12 TraceRoute Function
Use this screen to tell the switch to send a TraceRoute request to a specified IP address.You can use
this to discover the paths packets take to a remote destination. Once you click the Submit button, the
switch will send traceroute and the results will be displayed below the configurable data. If a reply to the
traceroute is you will see
1 x.y.z.w 9869 usec 9775 usec 10584 usec
2 0.0.0.0 0 usec * 0 usec * 0 usec *
3 0.0.0.0 0 usec * 0 usec * 0 usec *
Hop Count = w Last TTL = z Test attempt = x Test Success = y.