5 show ipv6 ospf database – Fortinet 548B User Manual
Page 570
- 570 -
Display Messages
Type: The type of the route to the destination. It can be either:
intra
— Intra-area route
inter
— Inter-area route
Router ID: Router ID of the destination
Cost: Cost of using this route
Area ID: The area ID of the area from which this route is learned.
Next Hop: Next hop toward the destination
Next Hop Intf: The outgoing router interface to use when forwarding traffic to the next hop.
10.4.1.5 show ipv6 ospf database
This command displays information about the link state database when OSPFv3 is enabled. If you do
not enter any parameters, the command displays the LSA headers for all areas. Use the optional
parameters to specify the type of link state advertisements to display. Use external to display the
external LSAs. Use inter-area to display the inter-area LSAs. Use link to display the link LSAs. Use
network to display the network LSAs. Use nssa-external to display NSSA external LSAs. Use prefix to
display intra-area Prefix LSAs. Use router to display router LSAs. Use unknown area, unknown as, or
unknown link to display unknown area, AS or link-scope LSAs, respectively. Use
link state ID (LSID). Use adv-router to show the LSAs that are restricted by the advertising router. Use
selforiginate to display the LSAs in that are self originated. The information below is only displayed if
OSPF is enabled.
Syntax
show ipv6 ospf [
nssa-external | prefix | router | unknown {area | as | link}}] [
Default Setting
None
Command Mode
Privileged Exec
User Exec
Display Messages
Link Id: Is a number that uniquely identifies an LSA that a router originates from all
other self originated LSA's of the same LS type.
Adv Router: The Advertising Router. Is a 32 bit dotted decimal number representing the