Fortinet 548B - Manual (Page 758)

- 758 -
Selection Criteria
MST ID - Selects one MST instance from existing MST instances.
Slot/Port - Selects one of the physical or LAG interfaces associated with VLANs associated with the
selected MST instance.
Configurable Data
Port Priority - The priority for a particular port within the selected MST instance. The port priority is
set in multiples of 16. For example, if you set the priority to any value between 0 and 15, it will be set
to 0. If it is tried to be set to any value between 16 and (2*16-1) it will be set to 16 and so on.
Port Path Cost - Set the Path Cost to a new value for the specified port in the selected MST
instance. It takes a value in the range of 1 to 200000000.
Non-Configurable Data
Auto-calculate Port Path Cost - Displays whether the path cost is automatically calculated
(Enabled) or not (Disabled). Path cost will be calculated based on the link speed of the port if the
configured value for Port Path Cost is zero.
Port ID - The port identifier for the specified port within the selected MST instance. It is made up
from the port priority and the interface number of the port.
Port Up Time Since Counters Last Cleared - Time since the counters were last cleared, displayed
in Days, Hours, Minutes, and Seconds.
Port Mode - Spanning Tree Protocol Administrative Mode associated with the port or LAG. The
possible values are Enable or Disable.
Port Forwarding State - The Forwarding State of this port.
Port Role - Each MST Bridge Port that is enabled is assigned a Port Role for each spanning tree.
The port role will be one of the following values: Root Port, Designated Port, Alternate Port, Backup
Port, Master Port, or Disabled Port.
Designated Root - Root Bridge for the selected MST instance. It is made up using the bridge priority
and the base MAC address of the bridge.
Designated Cost - Path Cost offered to the LAN by the Designated Port.
Designated Bridge - Bridge Identifier of the bridge with the Designated Port. It is made up using the
bridge priority and the base MAC address of the bridge.
Designated Port - Port Identifier on the Designated Bridge that offers the lowest cost to the LAN. It
is made up from the port priority and the interface number of the port.
Loop Inconsistent State - This parameter identifies whether the port is in loop inconsistent state.
Transitions Into Loop Inconsistent State - The number of times this interface has transitioned into
loop inconsistent state.
Transitions Out Of Loop Inconsistent State - The number of times this interface has transitioned
out of loop inconsistent state.
Command Buttons
Submit - Applies the new configuration and causes the changes to take effect. These changes will
not be retained across a power cycle unless a save configuration is performed.
Refresh - Refreshes the screen with most recent data.