Fortinet 548B - Manual (Page 746)

- 746 -
Operational Max Response Time - Displays maximum response time to be used in the queries that
are sent by the Snooping Querier.
11.3.17 Managing Port-Channel
11.3.17.1 Configuring Port-Channel Configuration Page
Selection Criteria
Port Channel Name – You can use this screen to reconfigure an existing Port Channel, or to create
a new one. Use this pull down menu to select one of the existing Port Channels, or select 'Create' to
add a new one. There can be a maximum of 6 Port Channels.
Link Trap - Specify whether you want to have a trap sent when link status changes. The factory
default is enable, which will cause the trap to be sent.
Administrative Mode - Select enable or disable from the pull down menu. When the Port Channel is
disabled no traffic will flow and LACPDUs will be dropped, but the links that form the Port Channel
will not be released. The factory default is enabled.
STP Mode - The Spanning Tree Protocol Administrative Mode associated with the Port Channel.
The possible values are:
Disable - spanning tree is disabled for this Port Channel.
Enable - spanning tree is enabled for this Port Channel.
Static Mode - Select static or dynamic from the pull down menu. The factory default is disabled.
Load Balance Mode - Select load balance mode from the pull down menu. The factory default is
Source XOR Destination MAC address.

Source MAC address - Sets the mode on the source MAC address.

Destination MAC address - Sets the mode on the destination MAC address.