Fortinet 548B - Manual (Page 479)

- 479 -
no - This command configures the interface to allow RIP control packets of the default version(s) to
be received.
Default Setting
Both
Command Mode
Interface Config
8.5.2.13 ip rip send version
This command configures the interface to allow RIP control packets of the specified version to be sent.
The value for is one of: rip1 to broadcast RIP version 1 formatted packets, rip1c (RIP version 1
compatibility mode) which sends RIP version 2 formatted packets via broadcast, rip2 for sending RIP
version 2 using multicast, or none to not allow any RIP control packets to be sent.
Syntax
ip rip send version {rip1 | rip1c | rip2 | none}
no ip rip send version
no - This command configures the interface to allow RIP control packets of the default version to be
sent.
Default Setting
rip2
Command Mode
Interface Config
8.6 Router Discovery Protocol Commands
8.6.1 Show Commands
8.6.1.1 show ip irdp
This commands displays the router discovery information for all interfaces, or a specified interface.