Fortinet 548B - Manual (Page 135)

- 135 -
- session number.
Default Setting
None
Command Mode
Privileged Exec
Display Message
Session ID: indicates the session ID.
Admin Mode: indicates whether the Port Monitoring feature is enabled or disabled. The possible
values are enabled and disabled.
Dest.Port: is the slot/port that is configured as the probe port. If this value has not been configured,
'Not Configured' will be displayed.
Sour.Port: is the slot/port that is configured as the monitored port. If this value has not been
configured, 'Not Configured' will be displayed.
Type: Direction in which source port configured for port mirroring.Types are tx for transmitted
packets and rx for receiving packets.
7.2.13.2 port-monitor session
This command configures a probe port and a monitored port for monitor session (port monitoring). Use
the source interface parameter to specify the interface to monitor. Use rx to monitor only
ingress packets, or use tx to monitor only egress packets. If you do not specify an {rx | tx} option, the
destination port monitors both ingress and egress packets. Use the destination interface to
specify the interface to receive the monitored traffic.
Syntax
port-monitor session {source interface [{rx | tx}] | destination interface
}
no port-monitor session { source interface | destination interface }
- Interface number.
tx/rx – Use to monitor ingress packets or egress packets.
no - This command removes the probe port or the mirrored port from a monitor session (port
monitoring).
Default Setting
None
Command Mode
Global Config