Fortinet 548B - Manual (Page 358)

- 358 -
Command Mode
Global Config
7.20.2.5 ip arp inspection trust
This command configures an interface as trusted for Dynamic ARP Inspection.
Syntax
ip arp inspection trust
no ip arp inspection trust
no - This command configures an interface as untrusted for Dynamic ARP Inspection.
Default Setting
Disabled
Command Mode
Interface Config
7.20.2.6 ip arp inspection limit
This command configures the rate limit and burst interval values for an interface. Configuring none for
the limit means the interface is not rate limited for Dynamic ARP Inspections.
Syntax
ip arp inspection limit {rate [burst interval ] | none}
no ip arp inspection limit
no - This command sets the rate limit and burst interval values for an interface to the default values
of 15 pps and 1 second, respectively.
Default Setting
15 pps for rate and 1 second for burst-interval
Command Mode
Interface Config
7.20.2.7 arp access-list
This command creates an ARP ACL.