Fortinet 548B - Manual (Page 318)

- 318 -
Default Setting
None
Command Mode
Global Config
This command uses to add an interface to a protected port group. The parameter
identifies the set of protected ports to which this interface is assigned. You can only configure
an interface as protected in one group.
Syntax
switchport protected <0-2>
no switchport protected <0-2>
no - This command uses to configure a port as unprotected.
Default Setting
None
Command Mode
Interface Config
7.16 Static MAC Filtering Commands
7.16.1 Show Commands
7.16.1.1 show mac-address-table static
This command displays the Static MAC Filtering information for all Static MAC Filters. If you select ,
all the Static MAC Filters in the system are displayed. If you supply a value for , you must
also enter a value for , and the system displays Static MAC Filter information only for that MAC
address and VLAN.
Syntax
show mac-address-table static { <1-3965> | all}
- Static MAC address.