3 radius server attribute 4, 4 radius-server dead-time, 5 radius-server host – Fortinet 548B User Manual
Page 260
- 260 -
7.8.4.3 radius server attribute 4
This command to set the NAS-IP address for the radius server.
Syntax
radius-server attribute 4 [ipaddr]
no radius-server attribute 4
no
– use this command to reset the NAS-IP address for the radius server.
Default Setting
None
Command Mode
Global Config
7.8.4.4 radius-server dead-time
This command cnfiguresradius server dead time.
Syntax
radius-server dead-time
no radius-server dead-time
Value - Set radius server dead time (sec). Range 1
– 255.
no - This command is used to set dead time to the default value.
Default Setting
255
Command Mode
Global Config
7.8.4.5 radius-server host
This command is used to configure the RADIUS authentication and accounting server.
If the 'auth' token is used, the command configures the IP address to use to connect to a RADIUS
authentication server. Up to 3 servers can be configured per RADIUS client. If the maximum number of
configured servers is reached, the command will fail until one of the servers is removed by executing the
no form of the command. If the optional
port number to use to connect to the configured RADIUS server. In order to configure the UDP port