Fortinet 548B - Manual (Page 610)

- 610 -
no - This command resets the register threshold rate for the Rendezvous Pointer router to the
default value.
Default Setting
0
Command Mode
Global Config
10.7.2.4 ipv6 pimsm rp-address
This command is used to statically configure the RP address for one or more multicast groups. The
parameter <rpaddress> is the IP address of the RP. The parameter <groupaddress> is the group
address supported by the RP. The parameter <groupmask> is the group mask for the group address.
The optional keyword override indicates that if there is a conflict, the RP configured with this command
prevails over the RP learned by BSR.
Syntax
ipv6 pimsm rp-address [override]
no ipv6 pimsm rp-address
no - This command is used to statically remove the RP address for one or more multicast groups.
Default Setting
0
Command Mode
Global Config
10.7.2.5 ipv6 pimsm rp-candidate
This command is used to configure the router to advertise itself as a PIM candidate rendezvous point
(RP) to the bootstrap router (BSR).
Syntax
ipv6 pimsm rp-candidate interface
no ipv6 pimsm rp-candidate interface
no - This command is used to disable the router to advertise itself as a PIM candidate rendezvous
point (RP) to the bootstrap router (BSR).