Fortinet 548B - Manual (Page 683)

- 683 -
System Up Time - The time at which this trap occurred, expressed in days, hours, minutes and
seconds since the last reboot of the switch.
Trap - Information identifying the trap.
Command Buttons
Clear Log - Clear all entries in the log. Subsequent displays of the log will only show new log entries.
11.2.13 Configuring SNTP
11.2.13.1 Configuring SNTP Global Configuration Page
Selection Criteria
Client Mode - Specifies the mode of operation of SNTP Client. An SNTP client may operate in one
of the following modes.

Disable - SNTP is not operational. No SNTP requests are sent from the client nor are any
received SNTP messages processed.

Unicast - SNTP operates in a point to point fashion. A unicast client sends a request to a
designated server at its unicast address and expects a reply from which it can determine the
time and, optionally the round-trip delay and local clock offset relative to the server.

Broadcast - SNTP operates in the same manner as multicast mode but uses a local
broadcast address instead of a multicast address. The broadcast address has a single
subnet scope while a multicast address has Internet wide scope.

Multicast - SNTP operates in the same manner as multicast mode and uses a local
multicast address.
Configurable Data
Port - Specifies the local UDP port to listen for responses/broadcasts. Allowed range is (1 to 65535).
Default value is 123.
Unicast Poll Interval - Specifies the number of seconds between unicast poll requests expressed
as a power of two when configured in unicast mode. Allowed range is (6 to 10). Default value is 6.