Fortinet 548B - Manual (Page 95)

- 95 -
7.2.6.16 show ip igmp snooping mrouter vlan
The user can go to the CLI Privilege Exec to display information about statically configured multicast
router-attached interfaces, use the show ip igmp snooping mrouter vlan Privilege command.
Syntax
show ip igmp snooping mrouter vlan
- Interface number.
Default Setting
None
Command Mode
Privilege Exec
Display Message
VLAN ID: Displays the list of VLANs of which the interface is a member.
Slot/Port: Shows the interface on which multicast router information is being displayed.
7.2.6.17 show ip igmp snooping static
The user can go to the Privilege Exec to display IGMP snooping static information, use the show ip
igmp snooping static Privilege command.
Syntax
show ip igmp snooping static
Default Setting
None
Command Mode
Privilege Exec
Display Message
VLAN: The VLAN ID used with the MAC address to fully identify packets you want L2Mcast Group.
MAC Address: The MAC address of the L2Mcast Group in the format 01:00:5e:xx:xx:xx.
Port: List the ports you want included into L2Mcast Group.
State: The active interface number belongs to this Multicast Group.