Fortinet 548B - Manual (Page 101)

- 101 -
Display Information
IGMP Snooping Querier Vlan Mode: Display the administrative mode for IGMP Snooping for the
switch.
Querier Election Participation Mode: Displays the querier election participate mode on the VLAN.
When this mode is disabled, up on seeing a query of the same version in the vlan, the snooping
querier move to non querier state. Only when this mode is enabled, the snooping querier will
participate in querier election where in the least ip address will win the querier election and operates
as the querier in that VLAN. The other querier moves to non-querier state.
Querier Vlan Address: Displays the Snooping Querier Address to be used as source address in
periodic IGMP queries sent on the specified VLAN.
Operational State: Specifies the operational state of the IGMP Snooping Querier on a VLAN.
Operational Version: Displays the operational IGMP protocol version of the querier.
7.2.7.11 show ip igmp snooping querier detail
This command display all of IGMP snooping querier information on the system.
Syntax
show ip igmp snooping querier detail
Command Mode
Privilege Exec
Display Information
IGMP Snooping Querier Mode: Administrative mode for IGMP Snooping. The default is disable.
Querier Address: Specify the Snooping Querier Address to be used as source address in periodic
IGMP queries. This address is used when no address is configured on the VLAN on which query is
being sent.
IGMP Version: Specify the IGMP protocol version used in periodic IGMP queries.
Querier Query Interval: Specify the time interval in seconds between periodic queries sent by the
snooping querier. The Query Interval must be a value in the range of 1 and 1800. The default value
is 60.
Querier Expiry Interval: Specify the time interval in seconds after which the last querier information
is removed. The Querier Expiry Interval must be a value in the range of 60 and 300. The default
value is 60.
7.2.8 MLD Snooping
7.2.8.1 show ipv6 mld snooping
The user can go to the CLI Privilege Exec to get all of mld snooping information, use the show ip mld
snooping Privilege command.