Fortinet 548B - Manual (Page 696)

- 696 -
Selection Criteria
VLAN ID - Select the VLAN for which information to be displayed or configured for DHCP Snooping
Application.
Configurable Data
DHCP Snooping Mode - Enables or disables the DHCP Snooping feature on selected VLAN. The
factory default is disabled.
Command Buttons
Submit - Applies the new configuration and causes the changes to take effect. These changes will
not be retained across a power cycle unless a save configuration is performed.
11.3.1.3 Configuring DHCP Snooping Interface Configuration Page
Selection Criteria
Slot/Port - Selects the interface for which data is to be displayed or configured.
Configurable Data
Trust State - If it is Enabled DHCP snooping application considers as port trusted. The factory
default is disabled.
Logging Invalid Packets - If it is Enabled DHCP snooping application logs invalid packets on this
interface. The factory default is disabled.
Rate Limit - Specifies rate limit value for DHCP Snooping purpose. If the incoming rate of DHCP
packets exceeds the value of this object for consecutively burst interval seconds, the port will be
shutdown. If this value is None there is no limit. The factory default is 15pps (packets per second).
The range of Rate Limit is (0 to 300).
Burst Interval - This Specifies the burst interval value for rate limiting purpose on this interface. If
the rate limit is None burst interval has no meaning shows it as N/A. The factory default is 1 second.
The range of Burst Interval is (1 to 15).
Command Buttons
Submit - Applies the new configuration and causes the changes to take effect. These changes will
not be retained across a power cycle unless a save configuration is performed.