Fortinet 548B - Manual (Page 815)

- 815 -
The default is RIP-2.
Receive Version - Which RIP version control packets will be accepted by the interface. The value is
one of the following:
RIP-1 - only RIP version 1 formatted packets will be received.
RIP-2 - only RIP version 2 formatted packets will be received.
Both - packets will be received in either format.
None - no RIP control packets will be received.
The default is Both.
RIP Admin Mode - Whether RIP is enabled or disabled on the interface.
Link State - Whether the RIP interface is up or down.
Command Buttons
Refresh - Refresh the data on the screen with the present state of the data in the switch.
11.4.5.3 Defining The Routing Interface’s RIP Configuration Page
Selection Criteria
Slot/Port - Select the interface for which data is to be configured.
Configurable Data
Send Version - Select the version of RIP control packets the interface should send from the
pulldown menu. The value is one of the following:
RIP-1 - send RIP version 1 formatted packets via broadcast.
RIP-1c - RIP version 1 compatibility mode. Send RIP version 2 formatted packets via broadcast.
RIP-2 - send RIP version 2 packets using multicast.