Fortinet 548B - Manual (Page 200)

- 200 -
Command Mode
Global Config
7.3.14.4 serviceport protocol
This command specifies the network management port configuration protocol. If you modify this value,
the change is effective immediately. If you use the bootp parameter, the switch periodically sends
requests to a BootP server until a response is received. If you use the dhcp parameter, the switch
periodically sends requests to a DHCP server until a response is received. If you use the none
parameter, you must configure the network information for the switch manually.
Syntax
serviceport protocol {none | bootp | dhcp | dhcp6}
none - Configure the network information for the switch manually.
bootp - Periodically sends requests to a BootP server until a response is received.
dhcp - Periodically sends requests to a DHCP server until a response is received.
dhcp6 - Periodically sends requests to a DHCPv6 server until a response is received.
Default Setting
None
Command Mode
Global Config
7.3.14.5 serviceport ipv6 enable
Use this command to enable IPv6 operation on the service port.
Syntax
serviceport ipv6 enable
no serviceport ipv6 enable
no - This command is disable IPv6 operation on the service port.
Default Setting
None
Command Mode
Global Config