Fortinet 548B - Manual (Page 369)

- 369 -
user notation.
To specify a match on all DSCP values, use the match [not] ip tos
command with <tosbits> set to 0 and <tosmask> set to 03 (hex).
Default Setting
None
Command Mode
Class-Map Config / Ipv6-Class-Map Config
7.21.2.13 match ip precedence
This command adds to the specified class definition a match condition based on the value of the IP
Precedence field in a packet, which is defined as the high-order three bits of the Service Type octet in
the IP header (the low-order five bits are not checked). The precedence value is an integer from 0 to 7.
Syntax
match ip precedence <0-7>
i
The ip dscp, ip precedence, and ip tos match conditions are alternative ways to specify a
match criterion for the same Service Type field in the IP header, but with a slightly different
user notation.
To specify a match on all Precedence values, use the match [not] ip tos
command with <tosbits> set to 0 and <tosmask> set to 1F (hex).
Default Setting
None
Command Mode
Class-Map Config
7.21.2.14 match ip tos
This command adds to the specified class definition a match condition based on the value of the IP TOS
field in a packet, which is defined as all eight bits of the Service Type octet in the IP header.
Syntax
match ip tos
<tosbits> is a two-digit hexadecimal number from 00 to ff.