Fortinet 548B - Manual (Page 297)

- 297 -
Syntax
lldp timers [interval ] [hold ] [reinit ]
no lldp timers [interval] [hold] [reinit]
- Configures the number of seconds to wait between transmitting local data
LLDPDUs
- Configures the multiplier on the transmit interval that sets the TTL in local data
LLDPDUs
- Configures the delay before re-initialization
no - This command is used to return any or all timing parameters for local data transmission on ports
enabled for LLDP to the default values.
Default Setting
Interval-seconds 30
Hold-value 4
Reinit-seconds 2
Command Mode
Global Config
7.12.2.8 lldp tx-delay
This command is used to set the timing parameters for data transmission delay on ports enabled for
LLDP. The determines the number of seconds to wait between transmitting local data
LLDPDUs. The range is 1-8192 seconds.
Syntax
lldp tx-delay
no lldp tx-delay
no - This command is used to return return the transmit delay to the default value.
Default Setting
2
Command Mode
Global Config