Fortinet 548B - Manual (Page 838)

- 838 -
IPv6 Mode - Enable IPv6 on this interface using the IPv6 address. This option is only configurable
prior to specifying an explicit IPv6 address.
IPv6 Address - Select list of configured IPv6 addresses for the selected Loopback interface. Add is
also a valid choice if the maximum number of addresses has not been configured.
IPv6 Address - When 'Add' is chosen from the IPv6 Address selector this IPv6 address input field
becomes visible. Address must be entered in the format prefix/length.
The user also has the option to specify the 64-bit extended unique identifier (EUI-64).
IPv4 Address - The primary IPv4 address for this interface in dotted decimal notation.
IPv4 Subnet Mask - The primary IPv4 subnet mask for this interface in dotted decimal notation.
Secondary Address - Select list of configured IPv4 secondary addresses for the selected Loopback
interface. Add Secondary is also a valid choice if the maximum number of secondary addresses has
not been configured. A primary address must be configured before secondary addresses can be
added.
Secondary IP Address - The secondary ip address for this interface in dotted decimal notation. This
input field is visible only when 'Add Secondary' is selected.
Secondary Subnet Mask - The secondary subnet mask for this interface in dotted decimal notation.
This input field is visible only when 'Add Secondary' is selected.
Command Buttons
Submit - Update the system with the values on this screen.
Delete Loopback - Remove the selected loopback interface.
Delete Primary - Remove the configured Primary IPv4 Address.
Add Secondary - Add the user specified Secondary IPv4 Address.
Delete Selected Secondary - Remove the selected Secondary IPv4 Address.
Delete Selected Address - Remove the selected IPv6 Address.
11.4.11.2 Viewing Loopbacks Summary Page
This page displays a summary of the configured Loopback interfaces.
Non-Configurable Data
Loopback Interface - The ID of the configured loopback interface.
Addresses - A list of the addresses configured on the loopback interface.
Command Buttons
Refresh - Refresh the page.