Fortinet 548B - Manual (Page 399)

- 399 -
i
The CLI mode changes to IPv6-Access-List Config mode when you successfully execute this
command.
Default Setting
None
Command Mode
Global Config
7.23.2.2 ipv6 access-list rename
This command changes the name of an IPv6 ACL. The parameter is the name of an existing
IPv6 ACL. The parameter is a case-sensitive alphanumeric string from 1 to 31 characters
uniquely identifying the IPv6 access list.
This command fails is an IPv6 ACL by the name already exists.
Syntax
ipv6 access-list rename
- current Access Control List name.
- new Access Control List name.
Default Setting
None
Command Mode
Global Config
7.23.2.3 {deny | permit} (IPv6)
This command creates a new rule for the current IPv6 access list. Each rule is appended to the list of
configured rules for the list.
!
The ‘no’ form of this command is not supported, since the rules within an IPv6 ACL cannot
be deleted individually. Rather, the entire IPv6 ACL must be deleted and respecified.
An imp licit ‘deny all’ IPv6 rule always terminates the access list.
A rule may either deny or permit traffic according to the specified classification fields. At a minimum,
either the ‘every’ keyword or the protocol, source address, and destination address values must be