Fortinet 548B - Manual (Page 818)

- 818 -
External 2 - Sets External Type 2 OSPF Routes to be redistributed
NSSA-External 1 - Sets NSSA External Type 1 OSPF Routes to be redistributed
NSSA-External 2 - Sets NSSA External Type 2 OSPF Routes to be redistributed
The default is Internal.
Distribute List - Distribute List - Sets the Access List that filters the routes to be redistributed by the
destination protocol. Only permitted routes are redistributed. If this command refers to a non-existent
access list, all routes are permitted. The valid values for Access List IDs are (1 to 199). When used
for route filtering, the only fields in an access list that get used are
Source IP Address and netmask
Destination IP Address and netmask
Action (permit or deny)
All other fields (source and destination port, precedence, tos, etc.) are ignored.
The source IP address is compared to the destination IP address of the route. The source IP
netmask in the access list rule is treated as a wildcard mask, indicating which bits in the source IP
address must match the destination address of the route. (Note that a 1 in the mask indicates a
"don’t care" in the corresponding address bit.)
When an access list rule includes a destination IP address and netmask (an extended access list),
the destination IP address is compared to the network mask of the destination of the route. The
destination netmask in the
access list serves as a wildcard mask, indicating which bits in the route’s
destination mask are significant for the filtering operation.
Command Buttons
Submit - Send the updated configuration to the router. Configuration changes take effect
immediately.
Delete - Delete the entry of the Source Route selected as Configured Source from the list of Sources
configured for RIP Route Redistribution.
11.4.5.5 Viewing Route Redistribution Configuration
This screen displays the RIP Route Redistribution Configurations.
Non-Configurable Data
Source - The Source Route to be Redistributed by RIP.