5 access-list – Fortinet 548B User Manual
Page 394
- 394 -
A rule may either deny or permit traffic according to the specified classification fields. At a minimum, the
source and destination MAC value and mask pairs must be specified, each of which may be substituted
using the keyword any to indicate a match on any value in that field. The bpdu keyword may be specified
for the destination MAC value/mask pair indicating a well-known BPDU MAC value of 01-80-c2-xx-xx-xx
(hex), where 'xx' indicates a don't care. The remaining command parameters are all optional.
The Ethertype may be specified as either a keyword or a four-digit hexadecimal value from
0x0600-0xFFFF. The currently supported
ipx, mplsmcast, mplsucast, netbios, novell, pppoe, rarp. Each of these translates into its equivalent
Ethertype value(s).
The vlan and cos parameters refer to the VLAN identifier and 802.1p user priority fields, respectively, of
the VLAN tag. For packets containing a double VLAN tag, this is the first (or outer) tag.
The assign-queue parameter allows specification of a particular hardware queue for handling traffic that
matches this rule. The allowed
queues available for the hardware platform.
The mirror parameter allows the traffic matching this rule to be copied to the specified
the redirect parameter allows the traffic matching this rule to be forwarded to the specified
The assign-queue and redirect parameters are only valid for a 'permit' rule.
Syntax
{del-rule-id | deny | permit} {{
[
Default Setting
None
Command Mode
Mac Access-list Config
7.22.2.5 access-list
This command creates an Access Control List (ACL) that is identified by the parameter.
Syntax
access-list {(<1-99> {deny | permit} {every |
| {{icmp | igmp | ip | tcp | udp |
[