Fortinet 548B - Manual (Page 505)

- 505 -
Command Mode
Interface Config
9.2.2.5 ip igmp query-interval
This command configures the query interval for the specified interface. This is the frequency at which
IGMP Host-Query packets are transmitted on this interface.
Syntax
ip igmp query-interval <1-3600>
no ip igmp query-interval
<1-3600> - The range for <1-3600> is 1 to 3600 seconds.
no - This command resets the query interval for the specified interface to the default value. This is
the frequency at which IGMP Host-Query packets are transmitted on this interface.
Default Setting
125 seconds
Command Mode
Interface Config
9.2.2.6 ip igmp query-max-response-time
This command configures the maximum response time interval for the specified interface, which is the
maximum query response time advertised in IGMPv2 queries on this interface.The time interval is
specified in tenths of a second.
Syntax
ip igmp query-max-response-time <0-255>
no ip igmp query-max-response-time
<0-255> - The range for <0-255> is 0 to 255 tenths of a second.
no - This command resets the maximum response time interval for the specified interface, which is
the maximum query response time advertised in IGMPv2 queries on this interface to the default
value. The maximum response time interval is reset to the default time.
Default Setting
100
Command Mode
Interface Config