Fortinet 548B - Manual (Page 609)

- 609 -
no - This command sets administrative mode of PIM-SM multicast routing across the router to
disabled. MLD must be enabled before PIM-SM can be enabled.
Default Setting
Disbaled
Command Mode
Global Config
Interface Config
10.7.2.2 ipv6 pimsm bsr-candidate
This command is used to configure the router to announce its candidacy as a bootstrap router (BSR).
Syntax
ipv6 pimsm bsr-candidate interface [hash-mask-length] [priority]
no ipv6 pimsm bsr-candidate
hash-mask-length - Length of a mask (32 bits maximum) that is to be ANDed with the group
address before the hash function is called. All groups with the same seed hash correspond to the
same RP. For example, if this value was 24, only the first 24 bits of the group addresses matter. This
allows you to get one RP for multiple groups.
priority - Priority of the candidate BSR. The range is an integer from 0 to 255. The BSR with the
larger priority is preferred. If the priority values are the same, the router with the larger IP address is
the BSR. The default value is 0.
no - This command is used to disable the router to announce its candidacy as a bootstrap router
(BSR).
Default Setting
None
Command Mode
Global Config
10.7.2.3 ipv6 pimsm register-threshold
This command configures the Register Threshold rate for the Rendezvous Point router to switch to a
source-specific shortest path. The valid values are from (0 to 2000 kilobits/sec).
Syntax
ipv6 pimsm register-threshold <0-2000>
no ipv6 pimsm register-threshold