Fortinet 548B - Manual (Page 49)

- 49 -
7.2.1.4 interface
This command is used to enter Interface configuration mode.
Syntax
interface
- is the desired interface number.
Default Setting
None
Command Mode
Global Config
7.2.1.5 speed-duplex
This command is used to set the speed and duplex mode for the interface.
i
The 10-Giga interfaces will not provide the following command. Instead, it provides a
command to set the speed of 10-Giga port to 1Gbps. Use
‘speed-duplex 1000’ to change the
speed of 10-Giga port to 1G speed.
Syntax
speed-duplex 1000
no speed-duplex 1000
1000 – 1000 Mbps, only valid for 10G ports.
no - This command will be back to 10G speed from 1G speed on a port.
Default Setting
None
Command Mode
Interface Config
This command is used to set the speed and duplex mode for all interfaces.
Syntax
speed-duplex all 1000
no speed-duplex all 1000
1000 – 1000 Mbps, only valid for 10G ports.