Fortinet 548B - Manual (Page 438)

- 438 -
nssa-external - Use nssa-external to display NSSA external LSAs.
opaque-area - Use opaque-area to display area opaque LSAs.
opaque-as - Use opaque-as to display AS opaque LSAs.
opaque-link - Use opaque-link to display link opaque LSAs.
router - Use router to display router LSAs.
summary - Use summary to show the LSA database summary information.
Lsid - Use to specify the link state ID (LSID). The value of can be an IP address or an
integer in the range of 0-4294967295.
adv-router - Use adv-router to show the LSAs that are restricted by the advertising router.
self-originate - Use self-originate to display the LSAs in that are self originated. The information
below is only displayed if OSPF is enabled
Default Setting
None
Command Mode
Privileged Exec
User Exec
Display Messages
Link Id: A number that uniquely identifies an LSA that a router originates from all other self
originated LSAs of the same LS type.
Adv Router: The Advertising Router. Is a 32 bit dotted decimal number representing the LSDB
interface.
Age: A number representing the age of the link state advertisement in seconds.
Sequence: A number that represents which LSA is more recent.
Checksum: The total number LSA checksum.
Options: This is an integer. It indicates that the LSA receives special handling during routing
calculations.
Rtr Opt: Router Options are valid for router links only.
8.3.1.6 show ip ospf database database-summary
Use this command to display the number of each type of LSA in the database for each area and for the
router. The command also displays the total number of LSAs in the database.
Syntax
show ip ospf database database-summary
Default Setting
None