Interlogix VEREX Director User Manual

Page 367

21-0381E v4.9.1

Welcome Report Control Admin Sys

Config

Tech-Ref

359

The following table shows keypad tones for the indicated conditions. Tones that are different for
“Standard” vs. “Reversed” are shown in bold.
Tip: “Standard” versus “reversed” tones is selectable under:
Account Information, Setup, ”

Arm/Disarm and Tones

”.

LCD keypad Tones

Condition

Standard Tones

Reverse Tones

Fire

1 second on and off.

Chime

Three 125 ms, short low level
beeps

Exit/Entry Delay

Slow turn on/off tones:
On Time: 250 ms
Off Time:750 ms

Steady continuous tone

Exit Delay with point open
(see note below)

Fast turn on/off tones
On Time: 250 ms
Off Time: 250 ms

Confirm Exit delay

Fast turn on/off tones
On Time: 250 ms
Off Time: 250 ms

Trouble – Alarm,
Area Fail to Arm
(see note below)

Steady continuous tone

Slow turn on/off tones:
On Time: 250 ms
Off Time:750 ms

Entry delay with
was/current in alarm

Very Fast turn on/off tones
On Time: 125 ms
Off Time: 125 ms

Area closing – 15 minutes

Three 125 ms, short tones.
Tones faster during last 5 minutes

Note: For conditions referencing this note, the tone will NOT be generated if the applicable area’s “Fail to Exit Mode” is
set to None/0 (zero).

Keypad Tone Reference (

V4.5 with V4.42 firmware)