Interlogix VEREX Director User Manual
Page 225
21-0381E v4.9.1
Welcome Report Control Admin
Sys Config
Tech-Ref
217
- Location: A suitable name or location
for the specific system main panel;
- Display Offsets (Repeating vs.
Unique Item-Numbers): With the
default setting of "1", the areas, doors,
etc. for each panel will be numbered
the same (e.g., 1
st
Panel, Area 1, 2,
3,… 2
nd
Panel, Area 1, 2, 3,… etc.).
This allows for accounts that span
multiple buildings. Setting the 'offsets'
allows item-numbers to be unique /
sequential (e.g., Area 1, 2, 3, ...17, 18,
etc.)—which is useful for multiple
panels in the same building.
Elevators: Door and elevator numbering is shared (1 -
32). As such, the 'Door' offset applies to elevators as
well. Floors: Floors are identified by name only. As
such, 'offsets' do not apply.
Setting Item-Numbers to Be Sequential:
For each
item (area, door, etc.), check the item-range
from the preceding panel, and then set the
'offset' for the panel to the lowest available*
number.
* To allow for Future Expansion: You can set the
'offsets' as if each panel had all items defined (areas,
doors, etc.). Tip: Be sure to add "1", to obtain the
next available number. Refer to the system capacities
for the number of items supported per panel.
- Panel Display Offsets: This shows the 'Display
Offsets' for all panels pertaining to an account,
plus the resulting item-range for each panel
based on the present "Display Offsets".
When You Select a Panel (under Configuration)
Quick Tip: "Logical tree View" must not be in effect.