Interlogix VEREX Director - Manual (Page 291)

21-0381E v4.9.1 Welcome Report Control Admin Sys Config Tech-Ref 283
Area Counter reaches Min
Considered 'empty'; User Count <= Minimum
Area Counter reaches Max
Considered 'full'; User Count >= Maximum
Area No Detected Activity
Area Activity Detected
Area 15 Min before Scheduled Arm to "On"
Area 15 Min before Scheduled Arm to "Stay"
Area 15 Min before Scheduled Disarm Arm to "Off"
Area Schedule in Window
Area Auto-Command Schedule In Window
Area Failed to Close
Area Any point in tamper in area
Area Armed with Bypasses in Effect
Area Force Armed
Armed with some input points 'tripped'.
Area User Lockout in Effect
Re: Bad Card/PIN monitoring.
Area Wandering Patient Detected
Area Version "E" Siren
Area Version "E" Confirmed Alarm Strobe
Area Version "E" Fire
Area Version "E" Personal Attack
Area Version "E" Unconfirmed Alarm
Area Version "E" Set/Unset
Area Version "E" Freezer/Fire Fault
Area Version "E" Bypass in Effect
Area Version "E" Confirmed Alarm
Confirmed alarm – European Version (Active
when more than one detector is activated
during a single armed state).
Area Failed to Arm
For more information see “Output to follow an
Area Fail to Arm” (≥V4.80)
Version "E": Pertains to European monitoring
requirements.
Point (if event occurs at a specific Point) :
Point Normal (OK)
Point Open (tripped or tampered--any time)
Point Open (disarmed)
Tripped or tampered when area is Off or
Stay)
Point Open (armed)
Tripped or tampered when area is ON
Point Alarm
Tripped when area is ON
Point Bypassed
Point Preprocess
Delay
PreAlarm Warning is in effect.
Point Tamper
Point
Point in Delay
Point is in Delay. Follows a Custom Pt Type
that has a time delay
.
Point Confirmed point command
Positive Confirmation of Point Command
Activation.
Output (pertaining to another output) :
Output Real Output is On
Output Equation is TRUE
Output Manual Command in Effect