Interlogix VEREX Director - Manual (Page 106)

98 Verex Director V4.9.1 User's Guide 21-0381E v4.9.1
Resetting the Antipassback Status for
Users in a Specific Area
From time-to-time, persons may be unable to
enter an area due to an antipassback violation
(such as if they entered or exited when the
system unlocked a door for someone else).
This can be corrected by resetting the
antipassback status for a specific area.
 Ensure you are connected with the specific
panel(s) as described previously.
 Open the Area Users screen:
MyTools Bar: Control & Status - Area Users
Tree: Control & Status, Panel Control & Status,

Areas, Area Users
 Access the "APB Reset" feature for an area:
Forms View: Select the desired area
at the bottom of window, and then click
[ APB Reset ].
Grid View: Locate your desired area in the list, and
click [...] under "Anti-Passback Reset".
 Respond to any additional messages that
appear.
Screen Reference
Control & Status Panel Control &
Status Areas Area Users

[ APB Reset ]
Antipassback (APB): A feature that blocks individual
cards from being used to:
+ Re-enter the same area, or;
+ Re-enter the facility from 'outside', and/or;
+ (Optional): Enter other areas;
…Unless they are recorded as exiting first--i.e., each
person must use their card/token at every reader they
encounter (that is set to "Detect Antipassback"). Tip:
This helps to protect against unauthorized card usage.
Resetting APB Status for an Individual and/or System-
Wide: You can also reset the antipassback status for
an individual and/or for all areas associated with
selected panel(s). For details, refer to "Resetting Users'
A`Status" (previous).
Enabling the Antipassback Feature: To enable
antipassback tracking for specific areas and doors, refer
to the "Antipassback" selections under "Areas and
Related Settings", and the "Detect Antipassback"
selection under "Reader 1 & 2 Settings for a Door".