Avago Technologies MegaRAID Fast Path Software - Manual (Page 393)

LSI Corporation Confidential | July 2011 Page 393
MegaRAID SAS Software User Guide Chapter 9: Monitoring Controllers and Its Attached Devices | Battery Learn Cycle
Figure 260: Set Learn Cycle Properties
4. Select one of the two automatic learn cycles:
— Select the Enable radio button to enable an automatic learn cycle.
— Select the Disable radio button to disable an automatic learn cycle.
5. You can delay the start of the next learn cycle up to 7 days (168 hours) by specifying
the hours in the Delay scheduled learn cycle by field.
6. Select the Remind me when to start a learn cycle check box to receive a reminder
to start a manual learn cycle.
NOTE: After selecting Disable, if you select Enable, the controller firmware resets the
battery module properties to initiate an immediate battery learn cycle. The Next Learn
cycle field (in
Figure 258 or Figure 259 ) will not be updated until the battery relearn is
completed. Once the relearning cycle is completed, the value in the Next Learn cycle
field will display the new date and the time of the next battery learning cycle.
9.20.2 Starting a Learn Cycle
Manually
To start the learn cycle properties manually, perform the following steps:
1. Click the Physical tab to open the Physical view.
2. Select the BBU icon in the left panel.
3. Select Go To->BBU->Start Learn Cycle.
Another way to start the learn cycle is to right-click the BBU icon and select Start Learn
Cycle from the pop-up menu.